If fixing your concrete driveway is on your home improvement project list, consider resurfacing. Resurfacing is a great way to make your existing concrete surface look like new. You can apply a coating directly to the concrete surface without having to tear anything, saving time, hassle and money. The new and fresh concrete has a beauty of its own.
If you like the look of fresh concrete, damaged concrete can be restored with a like-new finish, only stronger than bare concrete. Chipping, deep cracks and a severely degraded surface can be repaired with RestoreKoat from Concrete CraftTM. Especially economical for large projects such as driveways, our versatile repair mortar can repair damage and eliminate years of wear embedded in your driveway. The short answer is “yes.
If there are no problems with the underlying base on which the rejuvenating agent is poured, the new material will last. It adheres to the foundation, creates a seal and leaves a completely new concrete driveway. When working with cement-based products, always wear eye protection and waterproof gloves. Temperatures should stay above 50 degrees for at least 8 hours and should be protected from freezing for 24 hours after application.
Step 9 Wet dry with a fine mist of water for 24-48 hours at temperatures above 90 degrees. Resurfacing is a process that involves adding a new layer of concrete over the existing driveway. This is usually done when the driveway is still in good condition, but needs a fresh new look. The old surface is cleaned and repaired as needed, then a new layer of concrete is applied.
Or, if there is too much damage and crumbling, you may need to weigh the pros and cons of concrete resurfacing compared to the overlay creates a durable finish and a durable bond with the original concrete that will not chip, crack or peel. As long as your walkway is not completely cracked, you can coat the slab with a concrete rectifier, a non-shrinkable mixture of Portland cement, sand and polymer additives that fills the voids and achieves a uniform finish. If you work with a concrete driveway that is between twenty and twenty-five years old or older, you will benefit from a replacement. Concrete Craft can repair, restore or resurface your ugly driveway in a matter of days so you can move on with the most important things in life.
In addition, the resurfacing process is less labor-intensive and less damaging than replacing concrete. For a driveway with serious cracks, uneven surfaces and a damaged finish, PebbleKoat from Concrete CraftTM can eliminate all those problems with a beautiful and decorative river rock layer in one step. Ultimately, resurfacing can produce a high volume of cost-effective concrete restoration work for contractors. These assessments will help you decide if you should resurface, repair, or replace your concrete driveway.
If you think your concrete driveway has reached the end of the road, keep reading and learn how easy it can be to give it a second life. Over time, you may begin to notice small cracks on the surface of the concrete entrance. Once the restored concrete has hardened, spray with a gentle spray for 24 to 48 hours after applying the repaver to avoid plastic shrinkage cracks and premature stresses during the curing process. Situations may arise where you may wonder if you should re-pave your concrete driveway or complete the repair of the concrete driveway.
